Thinking about adding a skylight? The biggest concern is always leaks. Here's why ours don't leak: we build a structural curb between the rafters, wrap it in ice-and-water shield, install step flashing on all four sides, and re-shingle around the unit with proper overlap. Then we verify the seal from inside the attic. Burleson Roofing & Maintenance — leak-free skylight installation in Burleson.
Tubular skylights are the alternative for spaces where a full skylight isn't practical — small bathrooms, closets, interior hallways. A 10-inch or 14-inch dome on the roof captures daylight through a reflective tube that channels it to a ceiling diffuser. Smaller roof penetration, simpler flashing, and effective daylighting in spaces a traditional skylight can't reach.
Our Skylight Installation Process
Free Consultation
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Roof Opening & Framing
Precise opening cut through the roof deck. Structural curb framed between trusses with load-bearing headers. Every cut edge of the sheathing sealed. The curb is the structural foundation — we don't skimp on the framing.
Flashing & Waterproofing
Self-adhering ice-and-water shield on all curb faces. Step flashing along both sides lapped under each shingle course. Head flashing at the top, apron flashing at the bottom. Waterproof sealant at every overlap and transition. The flashing makes or breaks the installation.
Completion
Skylight unit set into the curb and flange sealed to the roof deck. Shingles re-laid around the unit with proper overlap. Inside, rigid insulation installed around the light shaft to prevent condensation. Interior trim finished. Watertight verified from the attic.
What Burleson Customers Say
"Best experience we've ever had with a home service company. On time, on budget, and the results exceeded what we expected. Truly top-notch."
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
"From the first phone call to the final walkthrough, everything was seamless. The team was courteous and efficient. Already recommended them to two friends."
Why Choose Burleson Roofing & Maintenance for Skylight Installation?
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Code Compliant
Every skylight installation meets TX building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Leak-Free Guarantee
Every skylight gets ice-and-water shield, step flashing on all four sides, counter-flashing, and sealant at every transition. Verified from inside the attic before we leave. If it leaks, we fix it free.